The Flyfisher 22 is a handsome center console with a bit of Downeast Maine styling. Designed by Van Dam Custom Boats specifically for saltwater flyfishing in the Northeast, the Fly Fisher 22 is ideal for both close inshore breaking surf and shallow protected water sight casting. The boat's performance range is between 32 and 50 mph with a range of approximately 200 nm staying in the suggested power range of 90-150 hp. With high fuel efficiency and low maintenance, this boat allows owners to explore and fish in a variety of conditions and bottoms.

The hull is cold-molded with WEST SYSTEM® 105/206 epoxies. Four laminated layers of Alaskan Yellow Cedar are onthe topsides and bottom; the transom is built of marine plywood (Meranti) with a solid mahogany overlay. All transverse and fore-aft structures are also built of marine plywood. The verystiff hull is covered with 10oz E-glass and epoxy resin, faired with WEST SYSTEM®, and primed and painted with AWLGRIP® creating a finish comparable to any fiberglass boat.

The Flyfisher 22 features a spacious cockpit with casting platforms forward and aft, center console and leaning post fabricated with Divinycell® and WEST SYSTEM®. Varnished Sipo makes this boat stand out from all other fishing boats of its size and weight. All deck hardware is stainless steel and flush-mounted keeping line snags to a minimum. Dry storage is available fore and aft in six separate lockers located below the casting platforms with secure rod storage for four 10’ 6” rods and reels. Cockpit sole, side decks and casting platforms are fiberglassed, painted with AWLGRIP® and coated in non-skid.

Flyfisher 22 Specifications

Engines

Power range from 90hp—150hp

Instrumentation

Full engine instrumentation

Standard “Horizon Eclipse” GX-1000S VHF

Ritchie F83 compass

Mechanical / Electrical

Aluminum fuel tank

Two 750-amp batteries

Battery switch

Custom waterproof control panel with circuit breakers

AFI Horn

LED lighting

LED center console mounted port/starboard LED navigation lights

Electric bilge pumps with float switches

Water/fuel separator filter

13.5" stainless helm wheel with power knob

Deck / Hull / Cockpit

Structure bonded with WEST SYSTEM® brand epoxy

Bottom: ¾" cold-molded Alaskan Yellow Cedar

Topsides: ½" cold-molded Alaskan Yellow Cedar

Hull sheathed with fiberglass for abrasion resistance

AWLGRIP ™ topside with contrasting boot top

Antifouling bottom paint

Non-skid deck and cockpit sole

Sipo toerail, coaming and trim

Stainless steel rubrail

8" bow cleat with G-10 chafe protection

6" stern and spring cleats

7# Fortress anchor w/chain and 100’ of rode

Stainless steel custom handrails on console

Sunbrella ™ cover for console & leaning post

U.S. Coast Guard safety package